| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN MACHINE OFF
|
| 2 |
|
LOCATE CHARGER PLUG ON THE BACK OF MACHINE AND PULL TO DISCONNECT IT
|
| 3 |
|
LOCATE THE DRAIN HOSES ON THE BACK OF THE MACHINE
|
| 4 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 5 |
|
PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 6 |
|
REMOVE THE 2 TANK BOLTS ON EACH SIDE OF THE MACHINE. THESE BOLTS ARE LOCATED AT THE FRONT OF THE MACHINE AT THE BASE.
| Wrench-Allen metric 6.0mm |
|
|
| 7 |
|
LIFT THE TANK TO OPEN THE MACHINE
|
| 8 |
|
REMOVE THE 2 SCREWS HOLDING THE CONTROL BOARD COVER
| Wrench-Allen metric 6.0mm |
|
|
| 9 |
|
PULL UP ON THE CONTROL BOARD COVER TO REMOVE IT FROM THE MACHINE
|
| 10 |
|
CUT OFF BAD SECTION OF WIRING, IF WIRE IS STILL LONG ENOUGH TO REACH THE CONTROL BOARD, STRIP WIRE ENDS A 1/4 IN AND REINSTALL TO GREEN CONNECTOR. IF WIRING IS TOO SHORT, SPLICE IN AN ADDITIONAL LENGTH, USE AN APPROVED CONNECTOR SUCH AS A WIRE NUT AND TAPE, THEN CONNECT TO GREEN CONNECTOR. REVERSE STEPS 6 THRU 9 TO REASSEMBLE MACHINE. RECONNECT CHARGER PLUG.
| Screwdriver-flat tip |
|
|